pats new project watch this space

[robbie.cee]

last night picked up the essex v6 engine i was promised apparantly it used to run a turbo system on it
im just gonna give it a bit of a check over and once its ok run it on lpg

any info on lpg kit that would work ??

[MinorMatt]

If your on carbs robbie any single point injection system...

BRC Just is one, but there are loads out there!

[pat stevens]

ive never messed with these injection systems tbh
but its a idea

[pat stevens]

last night picked up the essex v6 engine i was promised apparantly it used to run a turbo system on it
im just gonna give it a bit of a check over and once its ok run it on lpg

any info on lpg kit that would work ??

the last system i used on my mk2 was a £80 jeep cherokee sysyem off ebay and the adapter for the webber twin choke i also bought of ebay for £4.50
was really easy to fit

[robbie.cee]

result will look into this

[AlanN]

thought it was about time i started the arches on the drivers side

so spent the afternoon doing this
so
hopefully the outer arches should be finished by the weekend

[BigMonty]

I get a bit excited when I see this thread updated. Its going to look awsome.
How do you go about the log book ? does it have to be SVAd ?

[pat stevens]

not sure will have to check it out once its finished i doubt it though as its already registerd prob a update on wheel plan and weight

[k638kas]

looks ace that pat well done had a little noisy through after you suggested and them seen how the arches were built there ace

[weldmatt]

just read all 19 pages ..awesome build pat ...will keep an eye on this thread


well done

[camper extraudinair]

I take my hat off to you pat, the work you have
put into your van is incredible,
will it go through a seven foot width restriction.
how wide is it at the rear arches.
congratulations on the job so far i like your
thinking on the side & rear doors,
hope to see you & van at Transit mania next
year if i can make it.

[supZ]

this is going to be a monster when its finished

[hotrod247]

just read throo the 19 pages , end resuld gaw on floor that is gona be a work of art when its finished ,
cant wait to see the up dates , all credit to you pat youve done some amazing work

[pat stevens]

cheers gotta try and get some more done over weekend

[pat stevens]

spent a few hours finishing the outside of the drivers side arches today



just gotta do the underside of the arches over the next week
then work out the side skirts