Moderator: Luke

Neil wrote:is it not threaded

Luke wrote:if its the arched shaped plastic piece type then the bit needs priseing out then you can spin it round and there is a metal pin about ½" long this will come out of the eye on the cable then its fairly obvious what to do![]()
hope that helps - its easier to do than it is to describe

Luke wrote:no its a dead easy job - once you realise how its done![]()
if you slide a screwdriver between the plastic bit and the pedal and twist it the plastic bit should come uncliped![]()
then you spin it round and pull it away from the pedal and it unclips from the cable - but there is a pin left in the cable - make sure it doesnt fall out and get lost


Users browsing this forum: No registered users
This site contains affiliate links for which we may be compensated.