For about a month the immobilizer light has been flashing code 2 3 BUT the van has still been starting!
Until last week after a very cold night (related?) it wouldnt start. Immobilzer light still flashing 2 3. Pleanty of power in the battery - cranking over well. Sounds like no fuel. I only have one key with a transponder in it.
Had a mechanic check the codes B2139 - PCM identification not recognized by PATS - So got towed home.
Had auto electrician look at whos good with the coding - Key Transponder OK, been advised probably fuel pump and pcm needs changing but just before he went, disconected the key transceiver, connected a mk7 one, disconnected it, connected original - it started
Worked for a few hours then back non starting. Brought a new transceiver it made no difference, I put the old one back in - it started (is that related?) but then wouldnt again.
Have been looking for dodgy wiring but none detected so far. Tried many times to start today without success. Then turned key on and left it 5 mins. (immobilzer light - rapid flashing, changes to 2 3 code, then goes out). When light was out turned the key to crank - no success- engine cranks but does not start. switched off then immedaiately cranked again - it started! Now its starting on the drive each time but I expect to be caught out again tomorrow. Immobilzer light behaving normally now - goes out when engine running and no code flashing.
The instrument panel has been "dodgy in the past" revs and speed needle drops odometer shows ---- then it flicks back on. I have fixed this by resoldering the jointson the circuit board where the wire connector sits. Could a faulty instrument panel be causing the immobilizer problem? Would getting this changed be a reasonable next step before looking at the fuel pump?
Baffled now about whats causing it - Any ideas? Any help welcome. Thanks
