landrover wellers re-drill help

[spike72]

just bought some landrover wellers and need them re-drilled to fit my transit

does any one have the details to give to the engineer to get them re-drilled

i have searched the site and cannot not find it

please please help

ta spike

[Luke]

whereabouts are you i've got a jig to redrill them

[spike72]

i live in sunny aberystwyth in wales lol

[Luke]

dunno round there but in south wales theres plenty of engineering firms that'd do them for you

[spike72]

do you no the pcd and diameter of hole i no it needs a 30 degree camber for wheel bolt shoulder

[MrMPuk]

Depends on what van you have.

[spike72]

VIN Number: WF0EXXBDVEWR76674
Registration Number: S716NRG
Registration Date: 09.11.1998
Registration Country: GB


Primary Features
Build Date: 22.10.1998
Vehicle Line: Transit 95
Cab Style: Bus (M2)
Series: 115
Engine: Diesel 2.5 (70PS)
Transmission: 5-Speed Manual - MT75
Drive: RHD RWD
Axle Ratio: 4.56
Emission: 97 EC LDT Requirements
Territory: (+)"GB"
Paint: Diamond White 73
Interior Fabric: Windrush G-C

hope that helps

[MrMPuk]

5x160 then.

[spike72]

so 160x5 pcd 13 diameter hole with 30 degree camber could you confim this please

i am new to transits and forum so on a steep learning curve

thanks

[Luke]

the angle is 60 degrees - standard ford

i'm guessing you mean 60 deg when you say 30 but you measure the other side of the angle to be correct

[spike72]

ok thanks just want to get all the specs right before he drills them and i bugger up the rims lol

[Luke]

make sure he gets them bang on in the middle of the existing holes

[spike72]

pity i aint closer gettin nervose about getting it done in case give him wrong info

[Luke]

whats the width of the landy wellers have you tried them on the van some are very wide and stick out miles

[spike72]

16x7 i aint got em yet just won some on ebay

just want to get all info ready for when i take them to engineer