Ford Transit Forum - A forum for all things Ford Transit related

The tools you will need are 1/4 drive ratchet with various wobble extensions & 10mm end. You will also need some gasket seal, oil, grease, loctite and an M10 Bolt.

Ensure that Neutral is Engaged
Remove the gear cables from the top of the selector. Do this by pressing the plastic bits at either side and pulling the cables off.
[img]http://i193.photobucket.com/albums/z266/Dan_t88/DSCF0761.jpg[/img]

Undo the reverse switch and the breather tube.
[img]http://i193.photobucket.com/albums/z266/Dan_t88/DSCF0760.jpg[/img]

Before a new remote control can be used, it must be programmed. Up to four remote controls can be programmed.

To carry out the programming, the ignition key must be turned to position RUN and back to position OFF four times within 6 seconds.

The ignition is now switched off and the control module is in the programming mode for 10 seconds. This is indicated by illumination of the LED in the digital clock or by locking/unlocking.