*NOW BOOKED FOR 2026* Transitmania 17 @ Santa Pod 17th to 19th July 2026 *ALL DETAILS HERE*


MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Transit Mk6 & Mk7 Forum. All Transits 2000 - 2013

MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby mrmatt83 » Mon Jun 13, 2016 7:13 pm

Hi guys, I have searched for this infomation but couldnt find anything on here, I am hoping to replace the cam/crank sensor on my 11 plate SWB 2.2 FWD (6 speed) 115 300s

its apparently a £10 part and 20 min job.... if you know where to find the bugger!

the reason for this is, couple days ago i went to get some desiel on the way home and when i went to start up again it wouldnt fire, like the imobliser isnt switching off.
after pushing it out the way and trying again after 30 mins fired right up as normal, has done it a couple times since but only had to try it after a few minuites of running a couple times.
first thing in the morning or straight after work when been left a while no problems.

am i in the right thinking this is the problem?

if anyone has a pic of where it is and what im looking at or if i need to be under the van this would be a great help

Matt
mrmatt83
Newbie
 
Posts: 5
Joined: Mon Jun 13, 2016 7:00 pm

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby v8dave » Mon Jun 13, 2016 9:30 pm

The crank sensor is under the exhaust gas cooler on the bellhousing under a tin heatsheild.

The cam sensor is on the front of the cylinder head, right hand end. Above the inlet manifold and below the prv.

Get the codes read to confirm the fault before changing things.
mk7 08reg 2.4 T350 LWB MHR RWD
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on

Notice a trend there ? not too big and not too small
User avatar
v8dave
Transit Fanatic
Transit Fanatic
 
Posts: 3429
Joined: Sun Jan 24, 2010 10:23 pm
Location: Home counties

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby ned » Mon Jun 13, 2016 10:19 pm

When you say it doesn't start is it completely dead or turning over and not firing. N
RUST IS LIGHTER THEN CARBON FIBRE

57 transit 85t260 2.2 swb, moondust silver.
viewtopic.php?f=27&t=209987

03 transit 125t280 2.0 tdci swb 229,000 miles.
viewtopic.php?f=27&t=168296
User avatar
ned
Transit Extremist
Transit Extremist
 
Posts: 22775
Joined: Sat Jan 16, 2016 9:01 am
Location: Somewhere in time

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby mrmatt83 » Mon Jun 13, 2016 10:44 pm

It turns over but doesnt fire, had to use the van tonight and wouldnt start again until the temp gauage came down to the first marker (10 o'clock)

I didnt realise i was looking at two different sensors guys! I think i know someone who can lend me a code reader.

Any ideas for what i need to change before i code read just so i know of other common faults to back up the code reader?

Many thanks for your inputs so far guys

Matt
mrmatt83
Newbie
 
Posts: 5
Joined: Mon Jun 13, 2016 7:00 pm

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby ned » Mon Jun 13, 2016 11:33 pm

Personally I wouldn't change anything until you have the codes it can be an expensive guessing game otherwise,

When you say the temp gauge comes down where is it sitting when it doesn't start,

The temp is cylinder head temp not water so if the pcm thinks the head is getting too hot it will shut the engine down to avoid damage. N
RUST IS LIGHTER THEN CARBON FIBRE

57 transit 85t260 2.2 swb, moondust silver.
viewtopic.php?f=27&t=209987

03 transit 125t280 2.0 tdci swb 229,000 miles.
viewtopic.php?f=27&t=168296
User avatar
ned
Transit Extremist
Transit Extremist
 
Posts: 22775
Joined: Sat Jan 16, 2016 9:01 am
Location: Somewhere in time

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby v8dave » Tue Jun 14, 2016 12:42 am

After rereading the original problem I've realised I had the same thing until I changed the leak-off pipework seals. The little o rings on the injectors were damaged and the air leak when the engine was hot created starting problems.
mk7 08reg 2.4 T350 LWB MHR RWD
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on

Notice a trend there ? not too big and not too small
User avatar
v8dave
Transit Fanatic
Transit Fanatic
 
Posts: 3429
Joined: Sun Jan 24, 2010 10:23 pm
Location: Home counties

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby mrmatt83 » Tue Jun 14, 2016 12:18 pm

Sorrys guys totally lost on the o rings. Could you tell me if thats a job for a savy machanic and how much they cost and even if theres online instructions somewhere?
The temp goes half way as normal and cools down but only really paid attention to the temp gauge last night.
Thanks for you help and patience.
mrmatt83
Newbie
 
Posts: 5
Joined: Mon Jun 13, 2016 7:00 pm

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby v8dave » Tue Jun 14, 2016 1:13 pm

There is a pipe that links the top of each injector together and then back to the fuel filter.
All fuel injectors leak, how much depends on whether they are new, old or nackered.

The fuel system pipework from the tank to the main pump and all of the leak-off pipework runs at a partial vacuum due to fuel being sucked up from the tank.
Added to this the leak-off fuel get hot.
When the fuel is hot it is thinner and runnier - like any oil.
If the seals are tired or damaged they let air leak in more easily when the fuel is hot.
If air gets in too easily then the injection pump can not suck up the fuel from the tank.
Result is non start when hot.

The seals are easy to change, but also easy to damage.

Unless you can read the codes you don't know if it is this problem or a bad sensor.
mk7 08reg 2.4 T350 LWB MHR RWD
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on

Notice a trend there ? not too big and not too small
User avatar
v8dave
Transit Fanatic
Transit Fanatic
 
Posts: 3429
Joined: Sun Jan 24, 2010 10:23 pm
Location: Home counties

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby mrmatt83 » Tue Jun 14, 2016 1:49 pm

I have arranged the use of a code reader to get a a best idea of the fault. Im back to work on long night shifts now so wont really be able to spend time on it till the weekend but i will post again with whatvthe code reader comes up with :-)
mrmatt83
Newbie
 
Posts: 5
Joined: Mon Jun 13, 2016 7:00 pm

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby Cellutron » Thu Jan 19, 2017 9:01 pm

mrmatt83 wrote:I have arranged the use of a code reader to get a a best idea of the fault. Im back to work on long night shifts now so wont really be able to spend time on it till the weekend but i will post again with whatvthe code reader comes up with :-)


What happened in the end?
Did you find the source of the problem?
A leaky pipework don't suck air necessarily! Source of air intake must be where suction takes place.
Cellutron
Transit Addict
Transit Addict
 
Posts: 62
Joined: Mon Apr 25, 2016 2:46 am

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby v8dave » Thu Jan 19, 2017 10:01 pm

Cellutron wrote:A leaky pipework don't suck air necessarily! Source of air intake must be where suction takes place.

In a tdci the fuel system from the tank through the filter to the injection pump runs at less that air pressure.
The leak off pipework will also run at less than air pressure while the return fuel is cold.
Once the return fuel gets hot a thermostat in the filter housing switches over to send the hot fuel back to the tank, via the fuel cooler if fitted.
mk7 08reg 2.4 T350 LWB MHR RWD
mk6 X reg 2.4 T350 LWB MHR RWD - scrapped
mk4 J reg 2.5 L300 LWB MHR RWD - sold on

Notice a trend there ? not too big and not too small
User avatar
v8dave
Transit Fanatic
Transit Fanatic
 
Posts: 3429
Joined: Sun Jan 24, 2010 10:23 pm
Location: Home counties

Re: MK7 2.2 TDCI (duratourq) FWD cam/crank sensor location

Postby knobby1 » Thu Jan 19, 2017 11:04 pm

v8dave wrote:Once the return fuel gets hot a thermostat in the filter housing switches over to send the hot fuel back to the tank, via the fuel cooler if fitted.


Yeah...I've got one of those "coolers" under my van, at rear behind the fuel tank....when I first saw it I didn't know what it was...had to follow lines back to find out..! Bloody Ford.. :roll:

Lord Knobrot
2008 2.4L RWD 170+PS 6-speed 350 LWB High Roof..."Full Poverty Spec".

When I die, I want to go peacefully in my sleep like my Grandfather, not screaming like the passengers in his car..!
User avatar
knobby1
Transit Extremist
Transit Extremist
 
Posts: 18809
Joined: Tue Oct 21, 2014 1:36 am
Location: Brisbane, Australia


Return to Mk6 & Mk7 - Third Generation Transits



Who is online

Users browsing this forum: No registered users

This site contains affiliate links for which we may be compensated.